ProEco 1.5" Foam Jet Fountain Nozzle N111-150

1½" Foam Jet ProEco Fountain Nozzles:

• 1½" Foam Jet Nozzle - N111-150
• Water Level Dependent: To archive optimum appearance and performance position this nozzle at the recommended water level as shown below
• Comes in 1/2", 3/4", 1", 1½" and 2" Sizes
• Inlet: Female National Pipe Thread
• Brass Construction

N-111 Foam Jet Nozzle Display Height Chart & Recommended Water Level

HOW TO SELECT THE CORRECT PUMP FOR YOUR FOUNTAIN NOZZLE/NOZZLES

To select the correct pump for your fountain please follow the steps below

• Select the nozzle pattern desired
• Select the height (or diameter) desired for the nozzle
• Look at the chart to determine the GPM (or G) and Head (H) required for the nozzle.
• The pump you choose must have the required GPH flow at the HEAD indicated in order to achieve that size display.
• The GPM flow at specific HEAD heights will be indicated in the manual or advertising for the pump in question

TIP #1 - for multiple nozzles multiply the GPM required by the total number of nozzles desired. It is not necessary to increase the HEAD when adding multiple nozzles.

Tip #2 - If the pump you are viewing indicates flow in GPH (gallons per hour) instead of GPM (gallons per minute) you can divide by 60. 900 GPH equals 15 GPM.

Tip #3 - Try to select a pump that is slightly more powerful than required to allow for errors in calculation

Tip #4 - All charts assume pump to be positioned at or near the nozzles. If the distance between pump and nozzle/ nozzles is greater than 10 foot additional HEAD will need to be factored in.

SUGGESTION: If you have questions when calculating your requirements please give us a call at 706-865-0220 and we would be glad to assist you with it.